Matthew Calderon

If the kit is not working properly or the factory camera quit working, try these steps to fix the issue.Open the hood and locate the fuse box next to the battery. Remove the radio fuse for 5 second...

Follow these steps to update the SE-P14 & SE-P24. With the radio off, insert the SD card into the radio.  (Figure A) Turn the radio on and then press the NAV icon. Follow all the prompts to initial...

 This tutorial explains how to add a “highs” amp to a Stinger integrated radio kit. The vehicle must be non-amplified.Connect the speaker wires.Locate the speaker connector harness from the PAC int...

 This tutorial explains how to add a “highs” amp to a Stinger integrated radio kit. The vehicle must be non-amplified.Connect the speaker wires.Locate the speaker connector harness from the PAC int...

When installing the RB10JK11K, there have been a few instances where the the dash bezel will not want to "snap" into place unless extreme force is used. Below shows a modification for removing (2) ...

This tutorial is for wiring and configuration for the Stinger EM-JP-CAM, HDCAM10U, HDCAMJW, PHD220, and PHD5N1 cameras.Before power is applied to the camera the jumper loops must be configured.Blue...

The gain dial on the Stinger amplifier must be level matched to the source it is connected to. For this tutorial we will use the Stinger MT-1000.1 amplifier which has an input sensitivity gain from...

The following legacy firmware is only for the Heigh10 and should only be used if instructed to do so by Stinger Technical Support. These firmware files will only work with the Heigh10 “non-X” versi...

If the amplifier is not working and/or going into Protection, follow these steps to diagnose the problem. Is the power light for the amp on? If not, check all fuses on the circuit. If the fuses are...

If the volume knob has never worked, or did work but quit shortly after installation, follow these steps to correct the problem.Start the vehicle.On the radio, navigate to Settings / Load Defaults....