Adding cameras to a Heigh10+, Horizon10, or Horizon12 radio

To add a camera(s) to a Heigh10+, Horizon10, or Horizon12, follow these steps.

1. Connect the power and ground wires from the camera(s) to the power and ground wires on the kit labeled “Aftermarket Camera Power”. The connections used on the kit are bullet connectors.
2. Connect the yellow RCA jack from the camera(s) to the appropriate camera input on the radio.
   • Reverse Cam In: Backup camera. (*)
   • Cam 2 In: Left side blind spot camera.
   • Cam 3 In: Right side backup camera.
   • Cam 4 In: Front camera.
3. Navigate to the camera settings on the radio and enable the camera(s): Settings / Camera / Camera Setup.
   • Select the button labeled “None”, and then select the appropriate camera label.
   • Enable the trigger.
   • If a front camera is selected, back out of the menu one click and ensure “Switch to Front Camera after reverse” is selected if you desire the camera to be shown after you shift from reverse.
4. Inspect the cameras for functionality. Please note that you must drive over 3mph to inspect the blind spot cameras.

(*) Do not use this input in the Gladiator and Wrangler.